LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2011 >> Azera GLS >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transaxle Diagnosis >> DTC P0601: Internal Control Module Memory Check Sum Error >> Scantool Diagnostics >> Monitor GDS Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor GDS Data

  1. Ignition ON & Engine OFF.
  2. Connect GDS to Data Link Connector(DLC).
  3. Selet "Diagnostic Trouble Codes(DTCs)" mode and monitor "DTC Status" parameter.
  4. Clear recorded DTC using GDS.
  5. Ignition switch OFF ↔ Ignition switch ON 2~3 times and Selet "Diagnostic Trouble Codes(DTCs)" mode and monitor "DTC Status" parameter.
  6. Is the DTC present?

    YES 

    • PCM/TCM's ROM or DATA is changed by reprogram illegally.
    • Substitute with a known-good PCM/TCM and check for proper operation. If the problem is corrected, replace PCM/TCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Fault is intermittent caused by poor contact of PCM/TCM and DTC was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.