LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2011 >> Genesis 4.6 >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System Diagnosis (G8BA - GSL 4.6L) (1 Of 2) >> P0160 O2 Sensor Circuit No Activity Detected (Bank 2/Sensor 2) >> Monitor Scantool Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor Scantool Data

  1. Connect scantool to DLC (Data Link Cable).
  2. Warm up the engine to normal operating temperature.
  3. Monitor "HO2S" parameter on scantool.
    Fig 1: Normal Graph Of Front HO2S & Rear HO2S At Idle
    G06101724Courtesy of HYUNDAI MOTOR CO.
  4. Are the parameters displayed correctly?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair " procedure.

    NO 

    • Go to "TERMINAL AND CONNECTOR INSPECTION" procedure.
scientia non olet · About LEMON Manuals