Front Impact Sensor (FIS): Installation

CAUTION:

Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.

Install the new Front Impact Sensor.
Tighten the Front Impact Sensor mounting screw.
Tightening torque

: 5.9 ~ 6.9 Nm (0.6 ~ 0.7 kgf.m, 4.3 ~ 5.1 lb.ft)
Connect the Front Impact Sensor connector and install the front bumper. (Refer to REPLACEMENT
Reconnect the battery negative cable.
After installing the Front Impact Sensor, confirm proper system operation:
1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.