Repair procedures: Installation
- Install the OCS equipped seat cushion.
- Install the front seat assembly. (Refer to FRONT SEAT .)
- Reconnect the battery negative cable.
- After installing the OCS, confirm proper system operation:
- Turn the ignition switch ON, the SRS indicator should be turned on for about six seconds and then go off. Telltale lamp will turn on for 4 seconds and be turned off for 4 seconds. After the 8 seconds, it shall remain off if the OCS does not require suppression and the passenger airbag is enabled.NOTE: Be sure to perform OCS (PODS) reset with GDS after replacing OCS equipped seat cushion.
- Turn the ignition switch ON, the SRS indicator should be turned on for about six seconds and then go off. Telltale lamp will turn on for 4 seconds and be turned off for 4 seconds. After the 8 seconds, it shall remain off if the OCS does not require suppression and the passenger airbag is enabled.