Component Inspection

1. Verify that the accelerator pedal operate freely without binding between full closed and wide open position by operating the accelerator pedal.
2. Check for poor carpet fit under the accelerator controls pedal.
3. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure. If OK, go to next step as below.

1. IG KEY 'ON'.
2. Connect GDS and monitor the "APS2" parameter on the data list.

   Specification:  Refer to "SIGNAL WAVEFORM&DATA " in the "General Information".

   TEST CONDITION REFERENCE
   
   

   Test Condition	APS2
   Release a pedal fully	Approx. 0.29~0.38
   Depress a pedal fully	Approx. 1.93~2.18V

YES 

Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

NO 

Substitute with a known-good component and check for proper operation. If the problem is corrected, replace component and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.