LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2012 >> Equus Signature >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System Diagnosis (2 Of 2) - 5.0L >> DTC U0105: Lost Communication With Fuel Injector Control Module >> Scantool Diagnostics >> Monitor GDS Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor GDS Data

  1. Connect GDS to Data Link Connector (DLC).
  2. Warm up the engine to normal operating temperature.
  3. Monitor the "CAN" parameters on the GDS.

    Check "Transaxle type, Torque control request, etc" at the ECU service data mode.

    Check "TPS", "RPM", and "Idle Status" parameters among TCU's current data. (AT vehicle only)

    • Check "Transaxle type, Torque control request, etc" at the ECU service data mode.
    • Check "Transaxle type, Torque control request, etc" at the ECU service data mode.
  4. Are the parameters displayed correctly?

    YES 

    Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    Go to "TERMINAL & CONNECTOR INSPECTION " procedure.

scientia non olet · About LEMON Manuals