Repair Procedures: Removal

Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Remove the rear seat. (Refer to REAR SEAT .)
Remove the fuel pump service cover (A).

Fig 1: Locating Fuel Pump Service Cover
Courtesy of HYUNDAI MOTOR CO.
NOTE:
The wiring in between the fuel pump and the sub fuel sender is fastened to the vehicle. So please separate it before removing the fuel pump service cover in accordance with the procedures below.
1. Remove the sub fuel sender cover and disconnect the sub fuel sender connector. (Refer to SUB FUEL SENDER .)
2. Release the wiring clips (A) under the carpet.
  
  Fig 2: Identifying Sub Fuel Sender Wiring Clips
  Courtesy of HYUNDAI MOTOR CO.
Disconnect the fuel tank pressure sensor connector (A), and then remove the fuel tank pressure sensor.

Fig 3: Locating Fuel Tank Pressure Sensor Connector
Courtesy of HYUNDAI MOTOR CO.