LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2012 >> Tucson GL, Automatic Trans >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System Diagnosis (2 Of 3) >> DTC P0620: Alternator Control Circuit >> Scantool Diagnostics >> Monitor GDS Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor GDS Data

  1. Connect GDS to Data Link Connector (DLC).
  2. Engine start.
  3. Monitor "Alternator duty cycle, PWM signal" parameter on GDS.
    Fig 1: Monitoring Alternator Duty Cycle, PWM Signal Parameter On GDS
    G06871914Courtesy of HYUNDAI MOTOR CO.
  4. Are the parameters displayed correctly?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to VERIFICATION OF VEHICLE REPAIR .

    NO 

scientia non olet · About LEMON Manuals