| The power does not turn on. |
The fuse is disconnected. |
Replace with a suitable fuse. If the fuse is disconnected again, please contact your point of purchase or service center. |
| Device is not properly connected. |
Check to see that the device has been properly connected. |
| XM only goes through one category |
The XM mode is in category. |
Press the mode button to change to channel mode. |
| The CD does not play. |
The DISC has not been inserted or has been inserted upside down. |
Insert the disc properly so that the sides are facing the correct direction. |
| The DISC has been contaminated. |
Wipe dirt and other foreign substances from the DISC. |
| The vehicle battery is low. |
Charge the battery. If the problem persists, please contact your point of purchase or service center. |
| A disc which is not supported by the device has been inserted. |
Insert a disc which is supported for play by the device. |
| The sound does not work. |
- The volume level is set the lowest level.
- The connector is not properly connected.
- The device is currently fast-forwarding, rewinding, scanning, or playing in slow mode.
|
- Adjust the volume level.
- Check the connection state.
- The sound will not work when the device is fast-forwarding, rewinding, scanning, or playing in slow mode.
|
| The sound or video quality is low. |
- The DISC is dirty or scratched.
- Vibration is occurring from the position in which the conversion switch has been installed.
- The color and tone quality of the image is low.
|
- Wipe off water or dirt from the DISC. Do not use a disc which has been scratched.
- The sound may be short-circuited and the image distorted if the device begins to vibrate. The device will return to normal operation once the vibration has stopped.
- Aging of the video display and deterioration in performance may cause certain quality degradations.
|
| The USB does not work. |
- USB memory is damaged.
- USB memory has been contaminated.
- A separately purchased USB HUB is being used.
- A USB extension cable is being used.
- A USB which is not a Metal Cover Type USB Memory is being used.
- A HDD type, CF, SD Memory is being used.
- There are no music files which can be played.
|
- Please use after formatting the USB into FAT 12/16/32 format.
- Remove any foreign substances on the contact surface of the USB memory and multimedia terminal.
- Directly connect the USB memory with the multimedia terminal on the vehicle.
- Directly connect the USB memory with the multimedia terminal on the vehicle.
- Use a standard USB memory.
- Use a standard USB memory.
- Only MP3, WMA file formats are supported. Please use only the supported music file formats.
|
| The iPod is not recognized even though it has been connected. |
- There are no titles which can be played.
- The iPod firmware version has not been properly updated.
- The iPod device does not recognize downloads.
|
- Use iTunes to download and save MP3 files into the iPod.
- Use iTunes to update the firmware version and reconnect the iPod with the device.
- Reset the iPod and reconnect with the device.
|