LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2012 >> Tucson GL, Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 3) >> DTC P0136: O2 Sensor Circuit (Bank 1/Sensor 2) >> Inspection Repair >> W/Harness Inspection >> Ground Circuit Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Ground Circuit Inspection

  1. Ignition "OFF".
  2. Disconnect HO2S connectors.
  3. Measure resistance between ground terminal of HO2S (B1S2) harness connector and chassis ground.

    Specification:  Approx. 0 Ω

    Fig 1: Measuring Resistance Between Signal Terminal Of HO2S (B1S2) Harness Connector And Chassis Ground
    G06871595Courtesy of HYUNDAI MOTOR CO.
  4. Is resistance within the specification?

    YES 

    NO 

    • Repair or replace as necessary and go to VERIFICATION OF VEHICLE REPAIR .
      NOTE: HO2S must have a clean air reference to function properly. The air is obtained by way of the sensor wire (s). Do not attempt to repair the wire (s), connector, or the terminals.
scientia non olet · About LEMON Manuals