Repair Procedures: Removal

WARNING: This page is about a different car, the 2014 Hyundai Veloster and 2013 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.

Remove the floor console assembly.
(Refer to CONSOLE
Remove the cover (A).

Fig 1: Floor Console Assembly Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the select cable (B) by removing the snap pin (A).

Fig 2: Select Cable & Snap Pin
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift lever assembly (B) by removing the bolts (A-4ea).
Tightening torque:

9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 14.5 lb-ft)

Fig 3: Shift Lever Assembly & Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift cable (B) by removing the clip (A).

Fig 4: Shift Cable & Clip
Courtesy of HYUNDAI MOTOR AMERICA
Remove the retainer (A) after loosen the nut (B).
Tightening torque:

11.8 ~ 14.7 N.m (1.2 ~ 1.2 kgf.m, 87 ~ 10.8 lb-ft)

Fig 5: Retainer & Nut
Courtesy of HYUNDAI MOTOR AMERICA
Remove the following items.
1. Air cleaner assembly and air duct.
  (Refer to "AIR CLEANER .
2. Battery and battery tray.
  (Refer to "BATTERY .
Remove the shift & select cable.
1. Remove the pin (A) and washer (B).
2. Make unlock clip (C) and then remove the shift & select cable and the clip (C) from the bracket.
  
  Fig 6: Shift & Select Cable Pin, Washer & Unlock Clip
  Courtesy of HYUNDAI MOTOR AMERICA
  NOTE:
  - Do not reuse the clip (C).
Remove the shift cable at cabin room.