Repair Procedures: Replacement

WARNING: This page is about a different car, the 2014 Hyundai Veloster and 2013 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.

Remove the front wheel & tire.
Tightening torque:

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

Fig 1: Identifying Front Wheel & Tire
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: Be careful not to damage to the hub bolts when removing the front wheel & tire.
Remove the wheel speed sensor bracket (B) and wheel speed sensor (A).
Tightening torque:

(B, C) 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Fig 2: Identifying Wheel Speed Sensor And Bracket
Courtesy of HYUNDAI MOTOR AMERICA

Fig 3: Identifying Wheel Speed Sensor Mounting Bolt
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the stabilizer link (B) with the front strut assembly (A) after loosening the nut.
Tightening torque:

98.1 ~ 117.7 N.m (10.0 ~ 12.0 kgf.m, 72.3 ~ 86.8 lb-ft)

Fig 4: Identifying Front Strut Assembly And Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the strut mounting nut.
Tightening torque:

44.1 ~ 58.8 N.m (4.5 ~ 6.0 kgf.m, 32.5 ~ 43.4 lb-ft)

Fig 5: Identifying Strut Mounting Nut
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Tighten under unladen condition when installing.
Disconnect the front strut assembly (A) with the front axle by loosening the bolt & nut.
Tightening torque:

137.3 ~ 156.9 N.m (14.0 ~ 16.0 kgf.m, 101.3 ~ 115.7 lb-ft)

Fig 6: Identifying Front Strut Assembly And Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.