Component Inspection
- Check TPS resistance
- IG "OFF" and disconnect ETC Motor & TPS connector.
- Measure resistance between TPS power and TPS ground terminals of ETC Motor & TPS connector. (component side)
Specification: 1.6 ~ 2.4kΩ
- Is the measured resistance within specification?
YES
- Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.NOTE: There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by PCM. Before or after testing PCM on the vehicle, use this function to reuse the PCM on the others
NO
- Substitute with a known - good ECT motor & TPS and check for proper operation. If the problem is corrected, replace ECT motor & TPS and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
* Procedure of ETS Initialization
- Erase the trouble codes on PCM
- Turn the ignition key "OFF" until the main relay turns "OFF". (It will take about 10 sec.)
- Turn ignition key "ON" for more than 1 second to record the throttle motor position in the EEPROM
- Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.