Repair Procedures: Installation

Remove the ignition key from the vehicle.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
Install the SRSCM with the SRSCM mounting bolts.
Tightening torque [SRSCM Mounting Bolt]:

6.9 ~ 8.8 N.m (0.7 ~ 0.9 kgf.m, 5.1 ~ 6.5 lb-ft)

Fig 1: Locating SRSCM Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA

NOTE: Use new mounting bolts when replacing the SRSCM after a collision.
Connect the SRSCM harness connector.
Install the floor console. (Refer to the CONSOLE )
Connect the DAB, PAB, SAB, CAB, KAB and BPT connectors.
Reconnect the battery negative cable.
After installing the SRSCM, confirm proper system operation:
1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.