Scantool Data Analysis
- Connect GDS.
- IG "ON" and engine "OFF".
- Select "DTC Analysis" mode.
- After erase DTC, keep the vehicle condition within "the enable conditions" (Refer to "DTC DETECTING CONDITION " table).
- Is the same DTC occurred again?
YES
- Go to "SCANTOOL DATA ANALYSIS " procedure.
NO
- Fault is intermittent caused by poor contact in the sensor's and/or MFSW's connector or was repaired and MFSW memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Scantool Data Analysis
- IG "ON" & ENG "OFF"
- After connect GDS, select "Current Date" menu.
- Check whether "Wiper Switch" is turned to "ON" when the Wiper Switch is turned on.
Specification: Service data is switched. (ON ↔ OFF)
CAUTION: When wiper switch is turned on to each step, service data of wiper switch step should be displayed to ON same as wiper switch. - Is the service data normal?
YES
- Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to "TERMINAL AND CONNECTOR INSPECTION " procedure.