Accelerator Pedal Position Sensor: Service and Repair

Inspection

1. Connect the GDS on the Data Link Connector (DLC).
2. Turn the ignition switch ON.
3. Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.

Specification:Refer to "Specification"

Removal

1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2. Disconnect the accelerator position sensor connector (A).
3. Disconnect the accelerator control connector (B).
4. Remove the accelerator pedal in the direction of "Removal direction" in the figure after removing the installation bolt (B).










Installation

1. Installation is reverse of removal.

Accelerator pedal module installation bolt:
8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb-ft)