Fuel Tank Pressure Sensor: Service and Repair

Inspection

1. Connect the GDS on the Data Link Connector (DLC).
2. Measure the output voltage of the FTPS.

Specification:Refer to "Specification"

Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Remove the rear seat.

3. Remove the fuel pump service cover (A) in the trunk.




4. Disconnect the fuel tank pressure sensor connector (A), and then remove the fuel tank pressure sensor.






Installation

CAUTION:
- Install the component with the specified torques.
- Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

CAUTION:
- Insert the sensor in the installation hole and be careful not to damage.

1. Install in the reverse order of removal.