Common Specs & Procedures
TUCSON COMMON SPECS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATION | ||
| Torque | Torque values are in the text of the article. See AIR CONDITIONING SYSTEM article. | ||
| Axle Nut/Hub Nut | |||
| Front & Rear | 144.6 ~ 202.5 Ft. Lbs. (196.1 ~ 274.5 N.m) | ||
| Battery | SPECIFICATIONS | ||
| Brakes | |||
| Bleeding Sequence | BRAKE SYSTEM BLEEDING | ||
| Disc Brakes | |||
| Service Specifications | SPECIFICATIONS | ||
| Torque | SPECIFICATIONS | ||
| Charging | |||
| Generator | CHARGING SYSTEM | ||
| Torque | REMOVAL AND INSTALLATION | ||
| Drive Belts | |||
| Adjustment | Self-tensioning Drive belt tensioner | ||
| Routing | See "Identifying Drive Belt" Figure under REMOVAL . | ||
| Engine Cooling | |||
| General Service Specifications | SPECIFICATIONS | ||
| Radiator Cap Pressure | 14-19 psi | ||
| Thermostat R & I | THERMOSTAT | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | COMPRESSION PRESSURE INSPECTION | ||
| Oil Pressure | |||
| 2.0L | 15.6 psi at 1000 RPM. | ||
| 2.4L | 21.3 psi at 1000 RPM | ||
| Overhaul | ENGINE AND TRANSAXLE ASSEMBLY | ||
| Torque | TIGHTENING TORQUES | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate Torque | 86.8-93.9 Ft. Lbs. (117.6-127.4 N.m) | ||
| Fuel System | |||
| Pressure Specification | 46.9-52.6 psi | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE TEST | ||
| Fuel Filter R & I | FUEL PUMP | ||
| Ignition | |||
| Firing Order & Cylinder Identification | 1-3-4-2 Also see FIRING ORDER & CYLINDER IDENTIFICATION . | ||
| Ignition Wires (Resistance) | SPECIFICATIONS | ||
| Ignition Wires (Routing) | See "Identifying Intake/Exhaust CMPS Connectors, Injector Connectors And Ignition Coil Connectors" figure under REPAIR PROCEDURES | ||
| Spark Plug | |||
| Type | FK16HQR11 | ||
| Gap | 0.039-0.043 in. (1.0-1.1 mm) | ||
| Torque | 15-22 Ft. Lbs. (20-30 N.m) | ||
| Starting | |||
| Starter | SPECIFICATIONS | ||
| Torque | 31.1 ~ 39.8 lb-ft, 42.2 ~ 53.9 N.m | ||
| Wheel Alignment | |||
| Adjustment Specifications | ALIGNMENT | ||
| Torque | TIGHTENING TORQUE | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 65-80 Ft. Lbs. (38-108 N.m) | ||