LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2013 >> Veloster Base, Automatic DCT Trans >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel Delivery System - Non-Turbo >> Fuel Tank >> Repair Procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Removal

  1. Release the residual pressure in fuel line (Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE " .
  2. Remove the rear seat [LH] (Refer to "Seat ").
  3. Remove the fuel pump service cover (A).
    Fig 1: Fuel Pump Service Cover
    G08807100Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the fuel pump connector (A).
  5. Disconnect the fuel feed tube quick connector (B).
  6. Disconnect the fuel tank pressure sensor connector (C).
  7. Disconnect the vapor tube (D).
    Fig 2: Fuel Pump, Feed Tube Quick & Tank Pressure Sensor Connectors And Vapor Tube
    G08807101Courtesy of HYUNDAI MOTOR AMERICA
  8. Lift the vehicle and support the fuel tank with a jack.
  9. Remove the center muffler assembly (Refer to "Intake And Exhaust System ").
  10. Disconnect the fuel filler hose (A).
    Fig 3: Fuel Filler Hose
    G08807102Courtesy of HYUNDAI MOTOR AMERICA
  11. Remove the under cover (A) and the parking brake line installation bolt.
    Fig 4: Under Cover & Parking Brake Lines
    G08807103Courtesy of HYUNDAI MOTOR AMERICA
  12. Remove the fuel tank from the vehicle after removing the fuel tank band (A).
    Fig 5: Fuel Tank Bands
    G08807104Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals