LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2013 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Control System - Turbo) >> Boost Pressure Sensor (BPS) >> Repair Procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the boost pressure sensor connector (A).
  3. Remove the installation bolt (B), and then remove the sensor.
    Fig 1: Boost Pressure Sensor Connector With Installation Bolt
    G09151068Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals