Repair Procedures: Replacement
WARNING: This page is about a different variant/trim than selected.
- Turn off the ignition switch and then disconnect the battery (-) cable.
- Remove the lower cover on the crash pad.
(Refer to the CRASH PAD .
- Disconnect the TCM connector (A).
- Remove the mounting bolt and nut. Then remove the TCM (B).
TCM mounting bolt/nut:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
- Installation is the reverse of removal.