Common Specs & Procedures
AZERA COMMON SPECS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATION | ||
| Torque | Torque values are in the text of the AIR CONDITIONING SYSTEM article. | ||
| Axle Nut/Hub Nut | |||
| Front | 177-199 ft. lbs. (240-270 N.m) | ||
| Rear | N/A | ||
| Battery | Refer to BATTERY and CHARGING SYSTEM SPECIFICATION table under CHARGING SYSTEM . | ||
| Brakes | |||
| Bleeding Sequence | Refer to BRAKE SYSTEM BLEEDING and ESC BLEEDING OF BRAKE SYSTEM . | ||
| Disc/Drum Brakes | |||
| Service Specifications | SPECIFICATIONS | ||
| Torque | See TIGHTENING TORQUES . | ||
| Charging | |||
| Generator | Refer to ALTERNATOR and CHARGING SYSTEM SPECIFICATION table under CHARGING SYSTEM . | ||
| Torque | Refer to text under ALTERNATOR . | ||
| Drive Belts | |||
| Routing | Refer to Removing Drive Belt Figure under REMOVAL AND INSTALLATION . | ||
| Engine Cooling | |||
| General Service Specifications | Refer to Cooling System in Chart under SPECIFICATIONS . | ||
| Radiator Cap Pressure | 14-18 psi | ||
| Thermostat R & I | THERMOSTAT | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | COMPRESSION PRESSURE INSPECTION | ||
| Oil pressure | 18.77 psi at 1000 RPM | ||
| Overhaul | SPECIFICATIONS | ||
| Torque | Refer to TIGHTENING TORQUES SPECIFICATIONS table under SPECIFICATIONS . | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate Torque | 53-55 ft. lbs. (72-75 N.m) | ||
| Fuel System | |||
| Pressure Specification | 69.6-75.4 psi (480-520 kPa) | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE TEST | ||
| Fuel Filter Location | In fuel pump assembly. | ||
| Fuel Filter R & I | REPAIR PROCEDURES | ||
| Ignition | |||
| Firing Order & Cylinder Identification | 1-2-3-4-5-6: Also refer to FIRING ORDER & CYLINDER IDENTIFICATION article. | ||
| Spark Plug | |||
| Type | SILZKR7B11 | ||
| Gap | 0.0394-0.0433 in. (1.0-1.1 mm) | ||
| Torque | 11-18 ft. lbs. (15-24 N.m) | ||
| Starting | |||
| Starter | Refer to STARTING SYSTEM SPECIFICATION table under STARTING SYSTEM | ||
| Torque | 31.1-39.8 ft. lbs. (42.2-53.9 N.m) | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT | ||
| Torque | TIGHTENING TORQUE | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 65-80 ft. lbs. (90-110 N.m) | ||