Repair Procedures: Installation

NOTE: When replacing the ECM, the vehicle equipped with the smart key must be performed the procedure as below.

[In the case of installing used ECM]

Perform "Neutral mode" procedure with GDS. (Refer to TEACHING MODE PROCEDURE DESCRIPTION (STEP BY STEP) )
(Refer to SMART KEY SYSTEM )
Turn the ignition ON and OFF position after completing "ECM neutral mode".
Then the ECM key register process is completed automatically.

[In the case of installing new ECM]

Turn the ignition ON and OFF position after completing "ECM neutral mode".

Then the ECM key register process is completed automatically.

NOTE: This ECM is a PCM type that includes a Transaxle Control Module (TCM).

Threfore TCM must be performed TCM learning procedure after replacing or re-installing a TCM. (Refer to "AUTOMATIC TRANSAXLE CONTROL SYSTEM ")