LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2014 >> Veloster Base, Standard Trans >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 2) - Non-Turbo >> DTC P0139: O2 Sensor Circuit Slow Response (Bank 1 Sensor 2) >> Component Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

  1. Replace the HO2S.
  2. Clear DTC with GDS.
  3. Start the engine and warm it up until the radiator fan comes on (more than at least 10 minutes).
  4. Drive at a steady speed between 45-55 mph (72-88 km/h) for 120 sec.
  5. Stop and then maintain idle state.
  6. Check if HO2S sensor monitoring readiness is complete.
  7. Does the scan tool show DTC P0139?

    YES 

    Substitute with a known - good ECM and check for proper operation. If the problem is corrected, replace ECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NOTE: There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by ECM. Before or after testing ECM on the vehicle, use this function to reuse the ECM on the others

    NO 

    Troubleshooting is finished.

scientia non olet · About LEMON Manuals