Shift Lever Assembly Replacement

Remove the floor Interior console assembly.
(Refer to "INTERIOR (CONSOLE) ")
Remove the select cable snap pin (A) and the clip (B) from the select cable assembly.

Fig 1: Select Cable Snap Pin
Courtesy of HYUNDAI MOTOR AMERICA

Fig 2: Removing Select Cable Snap Pin And Clip
Courtesy of HYUNDAI MOTOR AMERICA
Remove the clip (A) from the shift cable assembly.
CAUTION: Set securely.

Fig 3: Shift Cable Assembly Clip
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift lever assembly (B) after removing shift lever assembly installation bolts (A-4ea).
Tightening torque:

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Fig 4: Shift Lever Assembly With Installation Bolts (A-4ea)
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.

NOTE:

Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.