Repair procedures: Removal

Separate the boot and remove the knob (A) by rotating it counterclockwise.

Fig 1: Knob
Courtesy of HYUNDAI MOTOR AMERICA
Remove the floor Interior console assembly.
(Refer to "FLOOR CONSOLE ")
Remove the air duct (A) by removing the nut.

Fig 2: Air Duct Nut
Courtesy of HYUNDAI MOTOR AMERICA
Remove the bracket cover (A) by removing the nuts.

Fig 3: Bracket Cover Nuts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the select cable (B) by removing the snap pin (A).

Fig 4: Select Cable And Snap Pin
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift lever assembly (A) by removing the bolts.

Fig 5: Removing Shift Lever Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift cable (B) by removing shift cable clip (A).

Fig 6: Shift Cable And Clip
Courtesy of HYUNDAI MOTOR AMERICA
Remove the main crash pad assembly.
(Refer to "MAIN CRASH PAD ASSEMBLY ")
Remove the heater unit.
(Refer to "HEATER UNIT ")
Remove the retainer (A) after loosen the nut (B).

Fig 7: Nuts And Retainer
Courtesy of HYUNDAI MOTOR AMERICA
Remove the engine cover.
(Refer to procedures found in "REPAIR PROCEDURES ")
Remove the air cleaner assembly and air duct.
(Refer to procedures found in "REPAIR PROCEDURES ")
Remove the battery and battery tray.
(Refer to "BATTERY ")
Remove the control cable.
1. Remove the pin (A).
2. Unlock the cable bracket clip (B) and remove it with the cable.
  
  Fig 8: Removing Cable Bracket Clips And Pins
  Courtesy of HYUNDAI MOTOR AMERICA
  CAUTION:
  - When removing the cable clip, spread it by pressing the "B" portion.
  - Replace the clip with a new one once it is removed.
  Fig 9: Cable Clips
  Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift cable at cabin room.