Repair Procedures: Installation
NOTE:
When replacing the TCM, the vehicle equipped with immobilizer must be performed the procedure as below.
[In the case of installing used TCM]
Then the TCM key register process is completed automatically.
[In the case of installing new TCM]
Then the TCM key register process is completed automatically.
[In the case of installing used TCM]
- Perform "Neutral mode" procedure with GDS.
(Refer to "IMMOBILIZER SYSTEM DIAGNOSIS - SONATA HEV article")
- Insert the key and turn it to the IGN ON and OFF position.
Then the TCM key register process is completed automatically.
[In the case of installing new TCM]
- Insert the key and turn it to the IGN ON and OFF position.
Then the TCM key register process is completed automatically.
- Install in the reverse order of removal.
TCM installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
TCM bracket installation bolt/nut: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)