TCM Terminal Input/Output Signal
CONNECTOR CHG-A TCM TERMINAL INPUT/OUTPUT SIGNAL
| Pin | Description | Condition | Input/output value | |
|---|---|---|---|---|
| Type | Level | |||
| 1 | - | - | - | - |
| 2 | - | - | - | - |
| 3 | Line pressure control solenoid valve (LINE_VFS) | - | Output | 0V/Battery voltage level |
| 9V < Battery voltage level < 16V | ||||
| 4 | Engine clutch control solenoid valve (EC_VFS) | - | Output | 0V/Battery voltage level |
| 9V < Battery voltage level < 16V | ||||
| 5 | 35R clutch control solenoid valve (35R/C_VFS) | - | Output | 0V/Battery voltage level |
| 9V < Battery voltage level < 16V | ||||
| 6 | Input speed sensor power | ON | Power | 0V/7.5V |
| OFF | ||||
| 7 | Output speed sensor power | ON | Power | 0V/7.5V |
| OFF | ||||
| 8 | Input speed sensor signal | High | Input | 0.7V/1.4V |
| Low | ||||
| 9 | Output speed sensor signal | High | Input | 0.7V/1.4V |
| Low | ||||
| 10 | - | - | - | - |
| 11 | - | - | - | - |
| 12 | - | - | - | - |
| 13 | - | - | - | - |
| 14 | - | - | - | - |
| 15 | - | - | - | - |
| 16 | - | - | - | - |
| 17 | Underdrive brake control solenoid valve (UD/B_VFS) | - | Output | 0V/Battery voltage level |
| 9V < Battery voltage level < 16V | ||||
| Power supply: V_SOL2 | ||||
| 18 | 26 brake control solenoid valve (26/B_VFS) | - | Output | 0V/Battery voltage level |
| 9V < Battery voltage level < 16V | ||||
| Power supply: V_SOL2 | ||||
| 19 | - | - | - | - |
| 20 | Overdrive clutch control solenoid valve (OD/C_VFS) | - | Output | 0V/Battery voltage level |
| 9V < Battery voltage level < 16V | ||||
| Power supply: V_SOL1 | ||||
| 21 | - | - | - | - |
| 22 | Rear lamp relay | R ON | Output | 0V/Battery voltage level |
| Other | 9V < Battery voltage level < 16V | |||
| 23 | - | - | - | - |
| 24 | - | - | - | - |
| 25 | Inhibitor switch signal "S2" | High | Input | 0V/Battery voltage level |
| Low | 9V < Battery voltage level < 16V | |||
| 26 | Inhibitor switch signal "S3" | High | Input | 0V/Battery voltage level |
| Low | 9V < Battery voltage level < 16V | |||
| 27 | Inhibitor switch signal "S4" | High | Input | 0V/Battery voltage level |
| Low | 9V < Battery voltage level < 16V | |||
| 28 | - | - | - | - |
| 29 | - | - | - | - |
| 30 | - | - | - | - |
| 31 | - | - | - | - |
| 32 | ON/OFF solenoid valve B (SS-B) | High | Output | 0V/Battery voltage level |
| Low | 9V < Battery voltage level < 16V | |||
| 33 | ON/OFF solenoid valve A (SS-A) | High | Output | 0V/Battery voltage level |
| Low | 9V < Battery voltage level < 16V | |||
| 34 | Ground (Power 1) | - | Ground | 0V |
| 35 | Ground (Power 2) | - | Ground | 0V |
| 36 | Sports mode down switch | Down ON | Input | 0V/Battery voltage level |
| Other | 9V < Battery voltage level < 16V | |||
| 37 | Sports mode up switch | Up ON | Input | 0V/Battery voltage level |
| Other | 9V < Battery voltage level < 16V | |||
| 38 | Sports mode select switch | Sport mode | Input | 0V/Battery voltage level |
| Other | 9V < Battery voltage level < 16V | |||
| 39 | - | - | - | - |
| 40 | Inhibitor switch signal "S1" | High | Input | 0V/Battery voltage level |
| Low | 9V < Battery voltage level < 16V | |||
| 41 | - | - | - | - |
| 42 | - | - | - | - |
| 43 | - | - | - | - |
| 44 | - | - | - | - |
| 45 | - | - | - | - |
| 46 | - | - | - | - |
| 47 | Solenoid supply power 1 | ON | Power | 0V/Battery voltage level |
| OFF | 9V < Battery voltage level < 16V | |||
| 48 | Solenoid supply power 2 | ON | Power | 0V/Battery voltage level |
| OFF | 9V < Battery voltage level < 16V | |||
| 49 | TCM Input power 1 (For solenoid) | - | Power | Battery voltage level |
| 9V < Battery voltage level < 16V | ||||
| 50 | TCM Input power 2 (For solenoid) | - | Power | Battery voltage level |
| 9V < Battery voltage level < 16V | ||||
| 51 | PWM_command | - | Output | 0V/Battery voltage level |
| 9V < Battery voltage level < 16V | ||||
| 52 | Status_OPU | - | Input | 0V/Battery voltage level |
| 9V < Battery voltage level < 16V | ||||
| 53 | Oil temperature sensor (-) | - | Ground | 0V |
| 54 | Oil temperature sensor (+) | ON | Input | 0V/3.3V |
| OFF | ||||
| 55 | CAN communication line (HIGH) | High | Command | - |
| Low | ||||
| 56 | CAN communication line (Low) | High | Command | - |
| Low | ||||
| 57 | - | - | - | - |
| 58 | - | - | - | - |
| 59 | - | - | - | - |
| 60 | - | - | - | - |
CONNECTOR CHG-K TCM TERMINAL INPUT/OUTPUT SIGNAL
| Pin | Description | Condition | Type | Level |
|---|---|---|---|---|
| 1 | Power ground | - | Ground | 0V |
| 2 | Battery power (B+) | ON | Power | 0V/Battery voltage level |
| OFF | 9V < Battery voltage level < 16V | |||
| 3 | Power ground | - | Ground | 0V |
| 4 | Battery power (B+) | ON | Power | 0V/Battery voltage level |
| OFF | 9V < Battery voltage level < 16V | |||
| 5 | ECU Ground | - | Ground | 0V |
| 6 | Battery power (B+) | - | Power | Battery voltage level |
| 9V < Battery voltage level < 16V |