Repair procedures: Replacement

Remove the Engine cover.
(Refer to procedures found in "REPAIR PROCEDURES ")
Remove the Air cleaner assembly and air duct.
(Refer to procedures found in "REPAIR PROCEDURES ")
Remove the Battery and battery tray.
(Refer to "BATTERY ")
Disconnect the back up lamp switch connector (A).

Fig 1: Back Up Lamp Switch Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the back up lamp switch (A).

Fig 2: Back Up Lamp Switch
Courtesy of HYUNDAI MOTOR AMERICA
Replace a new one and install the back up lamp switch.
Tightening torque:

39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)
Install in the reverse order of removal.