AV tail control
NOTE:
- During above ON/Off Filtering times, if a detected sensor value doesn't satisfy the ON/Off condition, filtering time counter is cancelled. When Tail lamp Off and Headlamp Off conditions are satisfied at the same time, Head Lamp Low and Tail Lamp are turned off simultaneous.
- These Filtering value is calibration value so it's changeable.
- In ACC terminal state, Tail Lamp and Head Lamp Low filtering times are not used; AV Tail Out filtering time is used even in ACC terminal state.
- These filtering times shall have an error tolerance of +/-100msec
Continuous Turn ON Mode
CASE (1): At the time that Tail Lamp and Head Lamp Low switch position are changed from manual ON to Auto ON position, if intensity of light measured by Auto light sensor that is already calculated satisfies the Head Lamp Low ON condition, Head Lamp Low is turned ON continuously without fluctuation
CASE (2): In the hysteresis range between level On and level Off, the current state of Lamp is kept.
CASE (3): As soon as the MFSW is changed to Off position, the lamp is turned Off immediately (Without Off delay times.)
NOTE:
Only in the terminal states of IGN and START, the Auto Light control functions of Tail lamp and head Lamp Low outputs can be active.