LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2016 >> Elantra Value Edition >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Airbag Modules & Clock Spring) >> Driver Airbag (DAB) Module and Clock Spring >> Repair Procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Removal

WARNING: This page is about a different car, the 2016 Hyundai Elantra GT and 2015 Hyundai Elantra GT. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  2. Remove the driver airbag module from the steering wheel after pressing the snap fit pin stopper.
    Fig 1: Removing Driver Airbag Module
    G10750585Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the wiring fixing clip (C) and disconnect the horn connector (A).
    Fig 2: Identifying Fixing Clip And Horn Connector
    G10750586Courtesy of HYUNDAI MOTOR AMERICA
  4. Release the connector locking pin, then disconnect the driver airbag module connector (B).
    CAUTION: The removed airbag module should be stored in clean, dry place with the pad cover facing up.
  5. Remove the steering wheel

    (Refer to: Steering System - "STEERING WHEEL ").

  6. Remove the steering column shroud.
    Fig 3: Removing Steering Column Shroud
    G10750587Courtesy of HYUNDAI MOTOR AMERICA
  7. Disconnect the clock spring and horn connector, then remove the clock spring.
    Fig 4: Identifying Clock Spring And Horn Connector
    G10750588Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals