LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2016 >> Genesis 5.0 >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Power Trunk Module >> Power Trunk Module Drive Unit >> Repair procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair procedures: Removal

CAUTION:
  1. Put on gloves before removing/installing the drive unit.
  2. Do not install or carry a push rod, controller and wire harnesses by holding it with bare hands.
  3. Be careful when removing the push rod, the trunk may close.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the left trunk trim after opening the trunk.

    (Refer to "TRUNK TRIM ")

  3. Separate the power trunk module push rod pin (A) and then remove the power trunk module connecting rod (B).
    Fig 1: Separating Power Trunk Module Push Rod Pin
    G10454512Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the power trunk module & drive unit (A) after disconnecting the connector, bolts and nuts.
    Fig 2: Power Trunk Module & Drive Unit
    G10454513Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the power trunk module (A) after loosening the mounting screws.
    Fig 3: Power Trunk Module
    G10454514Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals