Repair Procedures: Removal

Set shift lever to "N" position.
Remove the Air Duct.
(Refer to: Engine Mechanical System - "AIR CLEANER ").
Remove the Battery and the Battery Tray.
(Refer to: Engine Electrical System - "BATTERY ").
Disconnect the inhibitor switch connector (A).
Remove the shift cable mounting nut (B).
Tightening Torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Fig 1: Inhibitor Switch Connector And Shift Cable Mounting Nut
Courtesy of HYUNDAI MOTOR AMERICA
Remove the Manual Control Lever (B) and the washer after removing a nut (A).
Tightening Torque:

Fig 2: Manual Control Lever And Nut
Courtesy of HYUNDAI MOTOR AMERICA

17.7 ~ 24.5 N.m (1.8 ~ 2.5 kgf.m, 13.0 ~ 18.1 lb-ft)

CAUTION: Use a SST (09480-A3800) or 0.1969in.(5mm) bolt, fix the inhibitor Manual Control Lever in the 'N' jig hole (A) when you assemble the inhibitor (B).

Fig 3: N Jig Hole And Inhibitor
Courtesy of HYUNDAI MOTOR AMERICA
Remove the inhibitor assembly (A) after removing the bolts (2EA).
Tightening Torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 4: Inhibitor Assembly
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: When installing, tighten the inhibitor assembly mounting bolt to the specification displayed above.