Repair Procedures: Removal

CAUTION:

When the solenoid valve failure code (DTC) is on, perform the following procedure to replace it.
Automatic transaxle is composed of delicate components. Be careful not to cause any damage on the component in the course of assembly and disassembly.
Maintain clean condition so that foreign substance does not get into the automatic transaxle.
Use a coated apron, latex gloves, and stainless tray to prevent foreign substance from getting into the transaxle.
Automatic transaxle fluid (ATF) can be reused. Collect it using a clean 10-liter beaker.

Remove the Air Duct.
(Refer to: Engine Mechanical System - "AIR CLEANER ").
Remove the Battery and the Battery Tray.
(Refer to: Engine Electrical System - "BATTERY ").
Remove the under cover (A).
(Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ").
Remove the ATF warmer.
(Refer to Automatic Transaxle System-"ATF Warmer ") (if equipped ATF warmer).
Remove the drain plug (A) and reinstall the drain plug after draining ATF totally.
Tightening Torque:

38.2 ~ 48.1 N.m (3.9 ~ 4.9 kgf.m, 28.2 ~ 35.4 lb-ft)

Fig 1: Drain Plug Location
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: Replace the gasket before reinstalling the drain plug.
Remove the air bleeder hose (B) after removing the clamp (A).

Fig 2: Air Bleeder Hose And Clamp Location
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the clip for fixing wiring from the valve body cover.
Remove the valve body cover (A).
Tightening Torque:

(A) 13.7 ~ 15.7 N.m (1.4 ~ 1.6 kgf.m, 10.1 ~ 11.6 lb-ft)

Fig 3: Valve Body Cover
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- When re-mounting the valve body cover, replace the gasket (A) with a new one.
- After mounting the valve body cover, check for oil leakage on the connecting part while the Engine is ON.
Disconnect the solenoid valve connector (B) and the oil temperature sensor (A) after removing the bolts.
Tightening Torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 5: Solenoid Valve Connector And Oil Temperature Sensor Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the solenoid valve support bracket (A).
Tightening Torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 6: Solenoid Valve Support Bracket Location
Courtesy of HYUNDAI MOTOR AMERICA
Remove the Line pressure control solenoid valve (A).

Fig 7: Line Pressure Control Solenoid Valve Location
Courtesy of HYUNDAI MOTOR AMERICA