Verification of Vehicle Repair
WARNING: This page is about a different car, the 2017 Hyundai Santa Fe Sport. However, it is still accessible from the selected car via links, so may be relevant.
After a repair, it is essential to verify that the fault has been corrected.
- Connect GDS and select "Diagnostic Trouble Codes (DTC)" mode
- Clear DTC using a GDS.
- Drive the vehicle within DTC Enable conditions in General information.
- After selecting "Diagnostic Trouble Codes (DTC)" mode and check DTC is recorded again.
- Are any DTCs recorded?
YES
- Go to the applicable troubleshooting procedure.
NO
- System is performing to specification at this time.