Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the coupling assembly. (Proceed to Coupling Assembly - "REMOVAL ")
Remove the extension Cable (A).

Fig 1: Locating Coupling Assembly Extension Cable
Courtesy of HYUNDAI MOTOR AMERICA
Remove the pressure sensor (A) with 24mm socket.
NOTE:
- Keep going horizontal state to prevent leaks during remove the pressure sensor.
Tightening Torque :

7.8 ~ 9.8 N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2 lb-ft)

Fig 2: Locating Pressure Sensor
Courtesy of HYUNDAI MOTOR AMERICA