Repair Procedures: Replacement: Removal

CAUTION:

Remove the following parts.
1. Front Pillar Trim
  (Refer to: BD procedure - "INTERIOR TRIM ").
2. Inside Rear View Mirror
  (Refer to: BD procedure - "MIRROR ").
3. Wiper Arm
  (Refer to: BD procedure - "COWL TOP COVER ").
4. Cowl Top Cover
  (Refer to: BD procedure - "COWL TOP COVER ").
To remove the 'a' Pillar Garnish (A), loosen the Mounting Screw after removing the Cap (B).
Tightening Torque:

0.5 ~ 1.0N.m (0.05 ~ 0.1kgf.m, 0.4 ~ 0.7 lb-ft)

Fig 1: 'A' Pillar Garnish Mounting Screw
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the Windshield Glass Upper Molding (A).

Fig 2: Windshield Glass Upper Molding
Courtesy of HYUNDAI MOTOR AMERICA
Cut out the Sealant using the Sealant Cutting Tool (09861-31100).

Fig 3: Cutting Sealant Using Sealant Cutting Tool (09861-31100)
Courtesy of HYUNDAI MOTOR AMERICA
Remove the Windshield Glass (B) CAREFULLY using the Glass Holder (A).

Fig 4: Removing Windshield Glass Using Glass Holder
Courtesy of HYUNDAI MOTOR AMERICA