LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2017 >> Accent Value Edition >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System/Electronic Stability Control System Diagnosis >> DTC C1237: Primary Pressure Sensor-Signal >> Component Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

  1. IG "OFF".
  2. IG "ON".
  3. Connect GDS and select "Diagnostic Trouble Codes(DTC)  " mode.
  4. Using a GDS, Clear DTC.
  5. Check if the pressure sensor's service data shows '0 bar' on the GDS while not pressing the brake pedal.
  6. Use the GDS and check that the pressure sensor value rises while pressing the brake pedal.
  7. Is the pressure sensor's data unusually shown?

    YES 

    • Substitute with a known-good HECU and check for proper operation. If problem is corrected, replace HECU and then go to Verification Of Vehicle Repair procedure below.
    NOTE: * In a case of replacing HECU, operate following functions
    1. "Steering Angle Sensor Calibration" for steering angle sensor offset correction. Refer to Appropriate Service Information.
    2. "Longitudinal Sensor Calibration" for Longitudinal sensor offset correction. Refer to Appropriate Service Information.
    3. "Variant Coding" for type recognition (refer to C1702 )

    NO 

    • This fault is intermittently caused by pressure sensor. Go to Verification Of Vehicle Repair procedure below.
scientia non olet · About LEMON Manuals