Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe Sport. However, it is still accessible from the selected car via links, so may be relevant.

Remove the coupling assembly.
(Refer to Coupling Assembly - "DIRECT ELECTRO HYDRAULIC ACTUATOR COUPLING ")
Remove the extension Cable (A).

Fig 1: Removing Extension Cable
Courtesy of HYUNDAI MOTOR AMERICA
Remove the pressure sensor (A) with 24 mm socket.
NOTE:
- Keep going horizontal state to prevent leaks during remove the pressure sensor.
Tightening torque:

7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

Fig 2: Removing Pressure Sensor With Socket
Courtesy of HYUNDAI MOTOR AMERICA