Repair Procedures: Replacement

After loosening the mounting bolts, then remove the rear seat cushion assembly (A).
Tightening torque:

16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3~18.8 lb-ft)

Fig 1: Removing Rear Seat Cushion Assembly With Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the rear seat cushion heater connector (A).

Fig 2: Locating Rear Seat Cushion Heater Connector
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting bolts, then remove the rear seat back assembly (A).
Tightening torque:

16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3~18.8 lb-ft)

Fig 3: Locating Rear Seat Back Assembly With Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the rear seat back heater connector (A) and airbag connector (B).
[LH]

Fig 4: Locating Rear Seat Back Heater Connector (LH)
Courtesy of HYUNDAI MOTOR AMERICA

[RH]

Fig 5: Locating Rear Seat Back Heater Connector (RH)
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Make sure the connector is plugged in properly.