Signal Circuit Inspection

■ Check open in harness 

1. IG "OFF" and disconnect PCM and IDB connector.
2. Check resistance between CAN-HIGH terminal of PCM harness Connector and CAN-HIGH terminal of IDB harness connector.
3. Check resistance between CAN-LOW terminal of PCM harness Connector and CAN-LOW terminal of IDB harness connector.

   Specification:  Below 1.0 Ω

   Fig 1: Checking Resistance Between CAN-Low Terminal Of PCM Harness Connector And CAN-Low Terminal Of IDB Harness Connector

   Courtesy of HYUNDAI MOTOR AMERICA
4. Is the measured resistance within specification?

   YES 

   • Go to "COMPONENT INSPECTION".

   NO 

   • Repair open in CAN BUS line and go to "Verification of Vehicle Repair ".