Repair Procedures: Installation
- Remove the ignition key from the vehicle.
- Disconnect the battery negative cable and wait for at least three minutes before beginning work.
- Install the SRSCM with the SRSCM mounting nuts.
Tightening torque:
9.6 ~ 13.6 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.1 lb-ft)
NOTE: Use new mounting bolts when replacing the SRSCM after a collision.
When installing the SRSCM bolt, install the ground wire (B) with a bolt as indicated above picture. - Connect the SRSCM harness connector.
- Install the rear air vent duct and floor console.
(Refer to Body - "FLOOR CONSOLE ")
- Reconnect the battery negative cable.
- After installing the SRSCM, confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.