Repair Procedures: Replacement

Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
Remove the front wheel and tire (A) from front hub.
Tightening torque:

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

Fig 1: Removing Front Wheel And Tire From Front Hub
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: Be careful not to damage to the hub bolts when removing the front wheel and tire (A).
Remove the brake caliper mounting bolts (A), and then suspend the brake caliper (B) using a wire.
Tightening torque:

78.4 ~ 98.0 N.m (8.0 ~ 10.0 kgf.m, 57.8 ~ 72.3 lb-ft)

Fig 2: Removing Brake Caliper Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA

Fig 3: Locating Brake Caliper
Courtesy of HYUNDAI MOTOR AMERICA
Unstake the coking nut (A) then loosen and screw (B) then remove the front brake disc (C).
Tightening torque:
1. 274.6 ~ 294.2 N.m (28.0 ~ 30.0 kgf.m, 202.5 ~ 217.0 lb-ft)
2. 6.9 ~ 9.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~7.2 lb-ft)
Fig 4: Removing Front Brake Disc
Courtesy of HYUNDAI MOTOR AMERICA
Remove the tie rod end ball joint (A) from the knuckle.
1. Remove the split pin (C).
2. Remove the castle nut (B).
3. Use the SST (09568-34000).
Tightening torque:

23.5 ~ 33.3 N.m (2.4 ~ 3.4 kgf.m, 19.4 ~ 24.5 lb-ft)

Fig 5: Removing Tie Rod End Ball Joint From Knuckle
Courtesy of HYUNDAI MOTOR AMERICA

Fig 6: Removing Tie Rod End Ball Joint Using SST (09568-34000)
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the mount bolt and then remove the wheel speed sensor (A) from knuckle.
Tightening torque:

6.8 ~ 10.7 N.m (0.7 ~ 1.1 kgf.m, 5.0 ~ 7.9 lb-ft)

Fig 7: Removing Wheel Speed Sensor From Knuckle
Courtesy of HYUNDAI MOTOR AMERICA
Remove the lower arm (A) from the knuckle.
Tightening torque:

78.5 ~ 88.3 N.m (8.0 ~ 9.0 kgf.m, 57.9 ~ 65.1 lb-ft)

Fig 8: Removing Lower Arm From Knuckle
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the driveshaft (A) from the front hub assembly.

Fig 9: Disconnecting Driveshaft From Front Hub Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the strut mounting bolts and then remove the knuckle assembly (A).
Tightening torque:

137.3 ~ 156.9 N.m (14.0 ~ 16.0 kgf.m, 101.3 ~ 115.7 lb-ft)

Fig 10: Loosening Strut Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA