Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.

Installation is the reverse of removal.
NOTE:
- When installing, set control shaft lever to neutral position.
  
  Fig 1: Control Shaft Lever
  Courtesy of HYUNDAI MOTOR AMERICA
- When installing, apply the sealant as shown in the illustration below.
  Specified sealant: MS 721-40 or MS721-38
Fig 2: Locating Sealant Applying Area
Courtesy of HYUNDAI MOTOR AMERICA
After installing, check to be sure that this part operates as designed at each range of T/M side corresponding to each position of shift lever.