Repair Procedures: Installation

CAUTION:

Install the control cable (B) and clip (A) on the bracket.

Fig 1: Removing Control Cable And Clip On Bracket
Courtesy of HYUNDAI MOTOR AMERICA
Install the washer (B) and pin (A).

Fig 2: Installing Washer And Pin
Courtesy of HYUNDAI MOTOR AMERICA
Tighten the nut (B) after install the retainer (A).
Tightening torque:

11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)

Fig 3: Installing Retainer
Courtesy of HYUNDAI MOTOR AMERICA
Install the crash pad and cowl cross bar.
(Refer to "COWL CROSS BAR ASSEMBLY ")
Install the heater unit.
(Refer to "HEATER UNIT ")
Install the cable guide (B) on lever assembly.

Fig 4: Installing Cable Guide On Lever Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Install the shift cable (B) and clip (A).

Fig 5: Installing Shift Cable And Clip
Courtesy of HYUNDAI MOTOR AMERICA
Shift lever to "3rd".
Install the snap pin (A) after install the select cable (B).
CAUTION:
- Install the snap pin (A) after adjust the select cable (B).
(Refer to "Adjustment ")
Fig 6: Installing Snap Pin
Courtesy of HYUNDAI MOTOR AMERICA
Install the air duct (A).

Fig 7: Installing Air Duct
Courtesy of HYUNDAI MOTOR AMERICA
Install the floor console assembly.
(Refer to "FLOOR CONSOLE ")
Install the following items.
- Engine cover.
  (Refer to "ENGINE COVER ")
- Air cleaner assembly and air duct.
  (Refer to "AIR CLEANER ")
- Battery and battery tray.
  (Refer to "BATTERY ")