Repair Procedures: Removal

Remove the following items;
- Engine cover.
  (Refer to "ENGINE COVER ")
- Air cleaner assembly and air duct.
  (Refer to "AIR CLEANER ")
- Battery and battery tray.
  (Refer to "BATTERY ")
Set shift lever to N position.
Separate the control cable from the control shaft after remove the pin (A) and washer (B).

Fig 1: Removing Control Cable From Control Shaft
Courtesy of HYUNDAI MOTOR AMERICA
Remove the control shaft assembly after loosen the bolts.
Tightening torque:

19.6 ~ 26.5 N.m (2.0 ~ 2.7 kgf.m, 14.5 ~ 19.5 lb-ft)

Fig 2: Removing Control Shaft Assembly Bolts
Courtesy of HYUNDAI MOTOR AMERICA