Repair Procedures: Installation

Install in the reverse order of removal.
NOTE:
- When installing, set control shaft lever to neutral position.
  
  Fig 1: Setting Control Shaft Lever To Neutral Position
  Courtesy of HYUNDAI MOTOR AMERICA
- When installing, apply the sealant as shown in the illustration. Refer to (Fig 2).
  Specified sealant: MS 721-40 or MS721-38
  
  Fig 2: Applying Sealant
  Courtesy of HYUNDAI MOTOR AMERICA
  CAUTION:
  
  Check operating of lever of transaxle side when operating shift lever after assembly. (1-6, R)