LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2017 >> Elantra SE, Standard Trans >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Manual Transaxle Control System - 2.0L >> Control Shaft Assembly >> Repair Procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Removal

  1. Set shift lever to N position.
  2. Remove the air cleaner assembly and air duct.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  3. Remove the battery and battery tray.

    (Refer to Engine Electrical System - "BATTERY ")

  4. Remove the engine control module (ECM).

    (Refer to Engine Control System - "Engine Control Module (ECM) ") )

  5. Disconnect the shift cable (B) and the select cable (C) after removing the snap pin (A).
    Fig 1: Locating Shift Cable, Select Cable And Snap Pins
    G12025114Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the control shaft assembly (A) after loosening the bolts.

    Tightening torque: 

    19.6 - 26.5 N.m (2.0 - 2.7 kgf.m, 14.5 - 19.5 lb-ft)

    Fig 2: Removing Control Shaft Assembly
    G12025115Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals