LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2017 >> Elantra Sport, Standard Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 1.6L >> Engine Control Module (ECM) >> Repair Procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Removal

NOTE:
  • When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below.

[In the case of installing used ECM] 
  1. Perform "Neutral mode" procedure with GDS. (Refer to - "Neutralizing Of ECM "). (Refer to - "IMMOBILIZER SYSTEM ").
  2. Insert the key and turn it to the IGN ON and OFF position. Then the ECM key register process is completed automatically.

[In the case of installing new ECM] 

  • Insert the key and turn it to the IGN ON and OFF position.

Then the ECM key register process is completed automatically.
  1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the ECM Connector (A).
    Fig 1: Disconnecting ECM Connector
    G12024164Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the battery.

    (Refer to Engine Electrical System - "BATTERY ")

  4. Remove the installation bolts (A) and then remove the ECM (B).
    Fig 2: Removing ECM And Installation Bolts
    G12024165Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the ECM (B) after removing 4 nuts (A) from the bracket.
Fig 3: Removing Nuts From Bracket
G12024166Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals