Signal Circuit Inspection

■ Check voltage 

1. IG "OFF". Disconnect HO2S connector.
2. IG "ON"
3. Measure voltage between signal terminal of HO2S (B1S2) harness connector and chassis ground

   Specification:  Approx. 0.4~0.5V

4. Is voltage within the specification?

   YES 

   • Go to next step below.

   NO 

   • Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
   NOTE: HO2S must have a clean air reference to function properly. The air is obtained by way of the sensor wire(s). Do not attempt to repair the wire(s), connector, or the terminals.